PoE Extender (Dustproof and Waterproof) LAN-EXPOE4

[A dustproof and waterproof IP67 compliant PoE extender that supports PoE power reception of the IEEE802.3bt standard (up to 90W) and can extend LAN cables up to 100m.]

●This PoE extender supports PoE power reception of IEEE802.3bt (90W)/at (30W)/af (15.4W) and can extend PoE devices (IEEE802.3at/af) up to 100m while supplying power and communication.
*1, *2, *3, *4, *5, *6, *7, *8
●By receiving PoE power of IEEE802.3bt (supports up to 90W), this product can supply PoE power of IEEE802.3at (30W) and af (15.4W). *4, *5
●This industrial PoE extender complies with the IP67 dustproof and waterproof standard, enabling the transmission and extension of PoE signals outdoors.
●It operates in a wide range of environments with an operating temperature range of -10 to 50 degrees Celsius.
●Since the main unit operates on PoE power, no power cable is required when relaying/extending.
●By relaying up to 6 of these products, the LAN cable can be extended up to approximately 700m (1000Mbps). *2, *3, *4, *5, *6, *7, *8


*1 This is a theoretical value based on the LAN cable standard.
*2 The PoE power supplied when passing through this product will decrease due to power loss on the LAN cable and power consumption by the product itself.
*3 The maximum number of units that can be extended may differ because the power supplied differs depending on the standard of the PoE supply device and the cable length.
*4 The PoE supply device must be compatible with IEEE802.3af/at/bt, and the PoE device receiving power must be compatible with IEEE802.3at/af.
*5 If the PoE supply device is IEEE802.3af, PoE power output from this product will not be supported. (Power will be supplied, but the voltage and power output will not conform to the PoE standard.)
*6 For PoE power supply, please use a Category 5e/6/6a straight cable with a thickness of 24AWG or more.
Waterproof performance may not be achieved when using a LAN cable with a thickness of less than 24AWG.
*7 Please use a LAN cable with a LAN connector diameter of 13mm or less. If the LAN connector is 13mm or larger, it cannot pass through the waterproof cap.
*8 If the LAN connector has a latch cover, please cut off the latch cover before use.
Recommended cables (Sanwa Supply)
・KB-T6AAD series (23AWG) *Requires removal of the latch cover
・KB-T6POE series (22AWG) *Requires removal of the latch cover
・KB-T6TS series (23AWG)
・KB-T5T series (24AWG), etc.
*9 This product's PoE OUT only supports IEEE802.3af/at. IEEE802.3bt PoE devices are not supported.


■Number of ports: 1 port
■Maximum transmission speed: 1000Mbps (1000BASE-T)
■Compliant standards: IEEE802.3 (10BASE-T), IEEE802.3u (100BASE-TX), IEEE802.3ab (1000BASE-T), IEEE802.3x (Flow control for Full-Duplex)
PoE receiving port: IEEE802.3af/at/bt (90W)
PoE supplying port: IEEE802.3af/at (30W)
*Due to the power consumption of this product itself and the power reduction effect on the LAN cable, the power that can be supplied will be lower than the input power. Therefore, it will be slightly below the IEEE802.3af/at standard value, but it will still operate.
■Access Method: CSMA/CD
■Switching Method: Store & Forward
■Communication Mode: Full Duplex/Half Duplex
■Port Configuration: Input: IEEE802.3af/at/bt, 1000BASE-T/100BASE-TX/10BASE-T (RJ-45) AUTO-MDIX ×1 port,
Output: IEEE802.3af/at, 1000BASE-T/100BASE-TX/10BASE-T (RJ-45) AUTO-MDIX ×1 port,
■Auto MDI/MDI-X: Supported
■PoE Support: Supported
■PoE Port Output: af standard: 15.4W/1 port (maximum), at standard: 30W/1 port (maximum)
■PoE Power Supply Method: Alternative A
■Suitable LAN cable: Category 5e/6/6A straight cable with a thickness of 24AWG or more (PoE compatible)
*The LAN cable must have a connector diameter of 13mm or less.
*For connectors with latch covers, it is recommended to cut off the latch cover before use.
Recommended cables (Sanwa Supply):
KB-T6POE series (22AWG)
KB-T6TS series (23AWG)
KB-T5T series (24AWG)
etc.
■Buffer memory: 3Mbytes (dynamically allocated to each port)
■Flow control: Supported
■Maximum packet forwarding capacity: 1.518
■Filtering speed: 1,488,000 packets/sec (1000Mbps), 148,800 packets/sec (100Mbps), 14,880 packets/sec (10Mbps)
■Jumbo frame: Supported
■MAC address table: 2K
■Auto-negotiation: Supported
■Power consumption (maximum): Approx. 1.5
■Operating environment conditions: Temperature/-10 to 50 degrees, Humidity/10 to 90% (non-condensing) ■Storage environment conditions: Temperature/-40 to 70 degrees, Humidity/5 to 90% (non-condensing) ■Wall mountable: Yes ■Set contents: Product body x 1, Instruction manual (warranty) x 1, Waterproof connector x 2 (already attached to the main unit) ■Dustproof and waterproof standard: IP67